I figured I’d make one video talking about what I’m using. There’s some kinks to work out still that I didn’t expect. I filmed dropping the engine in, but still have to edit it and post. Hopefully I’ll have that up this weekend or early next...
Turns out the TT kit I got was for a pre 79 truck and won’t work. Luckily I had only pulled one spring.
So I pivoted to working on other external stuff.
I pulled everything off I wanted powdercoated and ran it up to Powder Keg
Next I got...
So I drove it to Ocracoke and back in early August, and that really took a toll on it.....
Starter quit
Pass. side front axle seal started leaking
Rear main seal is now aggressively leaking (used to be a small drip)
The thermostat housing gasket...
Spent the day running around collecting parts and such and the only wrenching was adding the new belts.
On the rear thin belt. I’m working with 2 thin pulleys and one thick one at the crank. That’s how it was before and it did not squeak...
It sure tried. It did kill the wife's minivan, which she is still somewhat mourning, and my little racecar (2016 Focus ST with all the goodies). I think it was just the Good Lord pointing me in the direction of the 80 finally.
Just before we left for the Fordyce trip we got a visit from @theglobb johnathan and Sophie
On there cross country trip exploring America.
Super nice people, had a great time just hanging out at the fire pit chatting and sharing breakfast in...
Had my 2000 since '08, just topped 300k and still going strong. Also have an 80 and 200 series. Use the forum a good bit, but just now finalizing log in!
Thanks.
I will used filler and high build primer to get everything straight.
I use a Hobart welder pretty much stick to chart for metal thickness, .030 wire.