Recent content by 3_puppies

  1. 3

    Replacement steering wheel options: OEM?

    any LC steering wheel from 1971? and up will fit on the splines problems may be turn canceling and any gaps between wheel and plastic on column
  2. 3

    87FJ60

    so the housing was broke above the oring. I've seen that once before.
  3. 3

    60/62 Fuel Tank?

    has the recall been done on your 60 series? Toyota still honors the recall, it takes some doing but it is possible IIRC the pickup in the 60 tank and the pump location on the 62 tank are in different places, you could probably make a pickup assembly to fit in the 62 location and then it would...
  4. 3

    Power steering fluid/ ATF smell thru vents

    it is another term I use for coolant, antifreeze. in the summer your not worrying about freezing but boiling. if there was a refrigerant leak, it would leak out as it is under pressure and then dissipate. I don't think it would be an on going smell another way to check would be to turn on the...
  5. 3

    OEM knock sensors vs aftermarket

    how old is the starter?
  6. 3

    Possible Transmission Issue

    before doing anything else I would drain the transfer case, leave plug out add atf to trans and see if any comes out the transfer drain you said you drained the transfer and only got gear oil I wouldn't waste my time fixing a small leak on the output shaft of the transfer until I figured out...
  7. 3

    Power steering fluid/ ATF smell thru vents

    are you sure it isn't an antiboil leak?
  8. 3

    Alternator went bad due to power steering pump leaking on it?

    I would suspect the hoses going to the ps pump before the pump itself. more investigation on the rack before declaring it needs replaced
  9. 3

    2006 LX470 – No Drive/Reverse, Rolls in Park, Screeching

    yes, you should be worried
  10. 3

    Input shaft bearing and Clutch kit Parts

    @cruiseroutfit cruiser outfitters ??
  11. 3

    87FJ60

    a crows foot or heal bar underneath won't pop it out of there? it is odd that it will raise up slightly but not come all the way out there is a gear on the shaft engaging the cam shaft and a flat on the bottom which engages the oil pump, along with the o ring and slip fit of the housing unless...
  12. 3

    help please! removing heater box from rhd BJ42 LX

    to answer the original question yes loosen the a/c box and drop down into the footwell area and that should give you the room needed not sure if you need to remove the shifter stalk nice buy need more pics of the rig
  13. 3

    The Wall of Shame

    nice crank pulley seems there is a bit more going on in the shackle pic, beside the not LC lug nut
  14. 3

    Keeps shredding belt

    the fan bracket is a shaft that has 2 sealed bearings, after many, many miles they will start having some play in them, if any play at all, replace it they can let loose and send the fan and fan clutch into the rad. if the fan bracket is removed and there is any sign of oil/grease seepage on...
  15. 3

    2UZ transmission thoughts.

    there is a USA made option to mount an H55 to 2UZ
Back
Top Bottom