Layonnn
Reactions
256

Latest activity Postings About Badges

    • Layonnn
      Layonnn reacted to hoser's post in the thread 130 amp alternator install in 00 LX with Like Like.
      1. There are two threaded studs in post #1. The one on the right is for the charge cable. The one on the left is not normally present, I believe. Perhaps it came on an aftermarket alternator. It’s not needed for the 100. 2. No alteration needed...
    • Layonnn
      Layonnn reacted to hoser's post in the thread 130 amp alternator install in 00 LX with Like Like.
      I had a chance to re-read this thread. Really good intentions on the OP's part but the information is not exactly accurate. AFAIK, this threaded stud is not necessary and not used. Likely used in a different application/vehicle. The pins are...
    • Layonnn
      Layonnn reacted to hoser's post in the thread 130 amp alternator install in 00 LX with Like Like.
      The "M or FR" pin is not used. Confirm the white wire is in the M position and cut off. Confirm all the wiring actually. I did not remove any mounting “tab” as seen in post 3. It fit as is. When installing your new alternator, you might find...
    • Layonnn
      Layonnn reacted to MongooseGA's post in the thread 130 amp alternator install in 00 LX with Like Like.
      I'm no electrician but I would assume the eyelet just goes to a nearby ground.
    • Layonnn
      Next you’ll need to remove the third mounting tab. Tape the alternator well to prevent scratches and debris from cutting. Again tape it very well! Then cut, smooth and polish. It’s aluminum so it cuts very easy. A hacksaw and a file will do just...
    • Layonnn
      Hey this is probably not news but just documenting my install should it help anyone. I’ve install a Denso remanufactured 130 amp alternator (part number 210-1099) as a PM/ upgrade to my stock 80 amp alternator. Fit guide shows this alternator...
  • Loading…
  • Loading…
  • Loading…
Back
Top Bottom