Recent content by 05ls430518

Find comps within a 50-100 mile radius as well as kbb or another appraisal type thing present it to them as facts cant argue with facts. Worst case scenario sue the s*** out of them insurance companies dont like lawsuits. I have done this numerous times because of them playing games. You can...

Not being a smart ass did you install anything backwards? When doing projects like this I have always noticed its a small stupid detail so easily overlooked, because we are trying to look at too big of a picture.

Yah no problem just giving back to everyone one else who has helped on the forum. Thats a huge issue because there is no way to wash the salt off due to it being behind the gas tank. I also noticed lexus did a revision of the part it looks like the top of the new one is completely flat. These...

So truck would crank no start, or would start then die immediately. Did some trouble shooting only codes that came up where useless P1603, P1604, and P1605. The fuel pcm came up as the issue after going through the trouble shooting steps. Here is a how to to replace it. 1.Drop the skid plate...

I do not know what was wrong with the original booster as it was defective before I did my brake work. It just an older vehicle and s*** happens unfortunately thats what I am coughing it up to. We dont really drive the LX very often, when a vehicle sits its usually worse for it them driving it...

Yupp that is correct had it replaced under warranty with lexus got a new one overnighted and truck has been driving fine drove it 2+ hour trip today no issues smooth as silk with braking.

I did the original brake booster was faulty as well, replacing it with another oem unit took care of the problems and the part was covered under lexus warranty.

Figured it out brake booster master cylinder was faulty my friends guess is it got knocked around in shipping. There was a dent I did not see on it that my friend pointed out when we compared them side to side. Thanks everyone for your help greatly appreciated!

I have the old ones still I will take a look I am 100% positive all 4 sides are experiencing heat I go around the truck put some water on the rotors and the water sizzle's for all 4 corners. I do not know if they drag when cold no way to tell, I am assuming they do because after 5ish minutes of...

So update its in my friends shop still can't find what's wrong wheels spin freely on a lift he is driving it around and going to use his thermal imager with him to check the hubs etc

ICE got him 🤣

So my ego is not to big to admit I have no idea whats causing this could be a chewed on wire could be any other number of things. I am having it flatbedded to my friends shop and I am going to have him look at it, and figure out what is causing the issue. I appreciate everyone sharing there...

You guys are still going on about how great CCN is come on, headgaskets are not a major issue with these trucks. CCN is not a Toyota g-d Paul Meeker owner of lextech is someone who I would listen to. Mike at FIGS engineering is another. You are buying an almost 10-15 year old vehicle. Unless...

So rod length is the same, there is no stored codes or pending codes I am stumped. The truck did this with the original oem calipers also that's what led me to replace all 4 calipers. I am open to any ideas at this point the brake booster master cylinder is defective, along with all 4...

Its possible I may need to lengthen the arm that goes to the pedal maybe its still engaging part of the way so the brakes are pressed down partially. I did not measure the lengths of the master cylinder/booster arm I cleared and read all codes there is nothing, I am going to check again for...