Recent content by 01dakar650

90311-48023 Was the correct part number. Thanks again!

This manual has the capacity and type for both transmissions. It also says you can use GL-4 and 5. I saw somewhere else on one of the forums here someone said you shouldn’t use GL-5 in the H55F, so this just complicates things 🤷‍♂️.

Ahh, that could be the issue then. I was not aware of that. I guess I got the newer retainer then. Hopefully that’s the one!! I’ll update the thread after I order one. Thanks for the insight.

90311-48010 is the part number for the original seal. Where did you find the other number 🤔. Did I miss that?

About two months ago while I was driving my 1986 JDM BJ70 SWB, H55F MT, the transfer case (the split case) leaked all the oil and seized. I didn’t notice until it was too late as the truck is very loud due to the new muffler location (right under drivers door) so I didn’t hear the whine from the...

Installed seatbelts in the back seat.

About the motor mounts, would simply replacing the old ones with new OEM mounts suffice or is there modification/strengthening required for the 4:1 gears?

Used front bumper off of a 1986 BJ70 Has a mount for winch (no winch anymore). The bumper has some dents, scratches and a small cosmetic crack in the chrome but still works. $300 obo

Upgraded the original differentials to Toyota OEM cable lockers and put 33 inch tires on it.

How do you like them?

$700 obo

They are missing what’s not there in the photos, with the exception of the Aisin locking hubs for the front. I did not have an extra set of brake components to put on unfortunately. And the front dust covers were not in good shape.

For sale, front and rear axle off of a 1986 BJ70. About 200k kilometers on the axles, non locking differentials, front disc and rear drum brake mount. These axles were in good working order before they were removed. I will be washing the dirt off before selling, so please pardon that. If you...

Ok. Some good points here. Thanks a lot for the insight everyone. I’ll just ensure to pick good lines 🤘.

Anyone out there ever do a spring over conversion on a SWB BJ70? I feel like the truck would be too tall for its width but I’m not sure.