I have Motive Bleeder with the fitting for a Toyota single master (80 series w/o ABS). Bench bleed the master.
Pump it to 15 psi and start driver rear/pass rear/pass front/driver front
If it’s got old fluid the motive will push fresh fluid...
Got the brakes on and new stainless hoses all around. New Hubs. Bled brakes.
Then I moved to the suspension. Got the rear 100% done and the 4* caster shims added to the front springs.
I’ll get them on tomorrow and roll it out for some glamor...
That's freaking cool. I have an air hammer and need to change out my rotors and wheel studs- does it drive them in and out just as well? I don't have a press and beating them in and out did not seem like the best way to do it.
you need to clearance the 'Advance Handling' rear S/R bracket or the spring eye will bottom on the plate behind the shackle. Let the eyelet swing free to the frame
Red left me for the night for dinner. I came back to the shop and got busy on some knuckles
It’s amazing how many people don’t know that Toyota bushing washers don’t cup the bushing, the lean out to allow for movement during flex.
In this post, I intended to establish a vision for the H55/1FZ clutch housing. I was near completion with our junky housing but I thought doing an H150 with the 3F is going to be fun; the whole thing cooled off.
I had it in an FJ80 and that...