Good afternoon,
So this morning upon finishing up a full transmission flush with a drop of the pan to replace the filter and check on the status of things (new to me rig - 242k), the last pan bolt I put in upon reinstalling the pan seems to of stripped. The M6x1.0 bolt threads fully in, but never tightens, just keeps spinning. Seems the threads in the aluminum trans are toasted? I need recommendations on the best way to go about a repair here? Time-sert? Bore out to a bigger bolt? Thanks for the help!
-Nick
So this morning upon finishing up a full transmission flush with a drop of the pan to replace the filter and check on the status of things (new to me rig - 242k), the last pan bolt I put in upon reinstalling the pan seems to of stripped. The M6x1.0 bolt threads fully in, but never tightens, just keeps spinning. Seems the threads in the aluminum trans are toasted? I need recommendations on the best way to go about a repair here? Time-sert? Bore out to a bigger bolt? Thanks for the help!
-Nick