Search results for query: *

Forum search Google search

  1. Mark Jennings

    Another 4-Speed Conversion Project

    It’s part #80 from SOR…it like a piece of 1/4 thick felt, maybe 3/8” diameter…..with a hole in the middle.
  2. Mark Jennings

    Another 4-Speed Conversion Project

    So when I installed my Bone-O-Drive, my Dakota Digital Speedo worked initially then went Ka-Put after a few miles. What I had found was the little brass key that goes into the Speedo shaft on the TC had slid out and wasn’t turning the cable. There is like a felt spacer that goes in there and...
  3. Mark Jennings

    Another 4-Speed Conversion Project

    You’ve done a tremendous amount of work and it looks like it turned out pretty awesome. Overcoming PO nightmarish issues (rear main bearing shims) and getting the 4 speed to sit correctly plus reutilizing the vacuum 4WD (the FD knob) engage and the original under dash Hi/Lo selector….you are...
  4. Mark Jennings

    Another 4-Speed Conversion Project

    Hi Green Been, great write up. I’m not sure you need to remove the oil pan for the main seal, the last one I did I think we just tapped a couple of sheet metal screws in the old one and used vice grips to pull it out???? Then used like a 2x2 to get the new one seated….anyway, great job.
Back
Top Bottom