Iv'e had my 95' FJ80 for about 7 years now, driven it all over the place. But it has always been so loud inside. I am running 35's with a fairly aggressive tread, but it seems like that is only part of the problem. I don't really hear wind noise, but it seems like I hear everything outside the...
I have a 95' FJ80
My brakes where working just fine, then suddenly, things got weird.
The pedal got very hard to push. ad the brakes didnt work well. If i let the pedal out for a second or two, it would go back to normal. Then, if I held the pedal down, for like a stop light, the pedal...
Howdy all.
When I bought my 96' 80 5 years ago, the a/c heater control never would move the mixer in the engine bay from hot to cold. I would have to pop the hood and move the mixer lever by hand.
Also the vents inside the truck would not completely close, so warm air might come from the...
Howdy all,
I am wanting to put the factory second gas tank in my 80. I see them here every now and then, saving up.
But I also want to add a wanter tank under the truck.
So......
If there is anyone out there that has the factory second tank, could you take a pic of how it sits when...
Ok, I'm getting a load roar from my rear axle when driving under load. there is play when I shake the rear yoke. I've got 250k on the rig, many of it hard miles.
So I need to fix the pinion bearing. and I might as well do the carrier bearing if I have to take it all apart. But that is...
Howdy all, I've been searching, but haven't found answer.
My front end has been making noise for a while. It makes a roaring sound when I accelerate, and goes quiet when I let off the gas.
when I last changed the diff oil, it had some metal shavings in the lube.
I just redid the birf and put...
So, I was about to work on rebuilding my Birfs.
And the other day, It seems like the bearing blew up. I started taking it apart and ran into a snag!
the center shaft, that the bearing go onto, has damaged threads. I was able to get the outer 52mm nut off, but it messed up the threads on the...
My two sons and I are driving out west, we are going through Colorado right now. Will end up in Lake Tahoe and doing the rubicon.
But I'm having trouble with my 95' fj80.
Recently I had a new a/c compressor done, replaced the alternator and had the valve cover gasket replaced.
I also had a...
My two sons and I are driving out west, we are going through Colorado right now. Will end up in Lake Tahoe and doing the rubicon.
But I'm having trouble with my 95' fj80.
Recently I had a new a/c compressor done, replaced the alternator and had the valve cover gasket replaced.
I also had a...
Howdy all, I did a search, but didn't see this issue.
My high beams don't turn on when I turn them on when I push the signal stalk forward to turn them on, but they DO turn on when I pull the stalk back to flash the high beams.
It could be the switch at the steering column, but wondered if...
Howdy all,
I was in some pretty deep muddy water the other day. I turned on my rear lockers about halfway through. My rear locker didn't work.
I checked all the wiring and I have power to the little compressor that actuates my locker. I took off the air connector, and a little water spit out...
I plugged in an inverter that my son wired backwards.
It knocked out my stereo and my clock.
I checked the fuses under the dash to the left of the steering wheeel. And I checked the fuse box on the left side of the engine compartment. None of the fuses where blown. But still no stereo.
Is...
Howdy all!
Two weeks ago is did some off road in Arkansas, did high water mark trail. Good times! Im not sure if this had anything to do with my issues, but thought I'd throw it out there.
So now, I was having problems with my brakes, and realized it was because the drivers side front wheel was...
Howdy all,
on my last raod trip, my passenger side front fender flare blew off! Ive patched in a few times.
Anyone have a spare, I could sure use it!
Thanks
Kent
My brakes on my 96' started grinding a few days ago, and got the pads to replace them. took off the passenger side, and the rotor is half ground down on the outside, the inside is normal.
what would cause it to grind so unevenly?
and does anyone have instructions on how to replace the rotors...
Howdy all.
I am about to hook up an antennae switch to be an inside winch switch. I have the switch out with the plug an harness.
Anyone know the wiring for the switch? power, up, down, light, etc? I figure more than one of you folks have done this.
Thanks
Kent
I am wanting to do a couple of things. Add a CDL switch, and figure out how to connect my door speakers.
I have read that my 96' althoug has no CDL switch, it has the plug. Is that the plug in the first picture? it has green, 2 black, and a green/white wire going to it.
Second. I used an...
Howdy all.
Been having issues with my front heater in my 96'. looked around here and did the normal stuff. valve switched, heater flushed, rear heater blowing hot.
So what is the next step. I know there is good flow through heater coil. I can even feel the warmth from under the dash.
My...
Howdy all.
Been having issues with my front heater in my 96'. looked around here and did the normal stuff. valve switched, heater flushed, rear heater blowing hot.
So what is the next step. I know there is good flow through heater coil. I can even feel the warmth from under the dash.
My...