Search results for query: *

  • Users: Rich
  • Order by date

Forum search Google search

  1. R

    Builds The Minipi Cruiser Build

    Which speakers are you replacing (dashboard, driver door, front/rear pass doors, rear ceiling, cargo area wall)? What model Sony speaker are you using?
  2. R

    For Sale MAF fzj80

    I'm interested in purchasing the MAF (also sent PM). Rich
  3. R

    For Free 97' AC lines and dryer bracket

    AC parts I would like the AC parts.
  4. R

    Washer bottle dual batteries and supercharger

    Here's our installation: factory washer bottle using Slee bracket. I manufactured the bracket at the bottom of the photo.
  5. R

    Parting 3 locked 1996 FZJ80's

    I have a '97 40th Edition 80 Series - with 2-tone interior. Do you have ivory grab handles that go with the interior of my 80?
  6. R

    For Sale Part Out - Sage 40th 80 Series

    Do you have grab handles (for cargo area)?
  7. R

    For Sale FZJ80 center caps in MS

    Hi - I'm interested in purchasing the hub caps. How can I purchase? Holly & Rich
  8. R

    IH8MUD Vendor Challenge #1

    Rich votes for 4...but with a mean case of aphasia he can't say why.
  9. R

    Where is water coming from - drivers floor

    Thanks, all, for your great input. Rich and I spent some time troubleshooting and suspected it was the sunroof drain, but unfortunatley couldn't find them on our own, so with the help of our local Toyota dealer, they cleared the drains and water-tested for several hours and hopefully that will...
  10. R

    Where is water coming from - drivers floor

    No, it's the original windshield!
  11. R

    Where is water coming from - drivers floor

    I noticed last night that the floor at the drivers seat is wet from rain. I'm going to go out there and investigate this morning. Seems like door and window were shut tight. Is there a known problem here? Any suggestions where the water could be coming from? First time this has happened in...
  12. R

    K&N Air filter for SuperCharger?

    I think one could just pull the factory air inlet hose off of the throttle body, toss in some dirt, put the hose back on, leave the factory air filter installed, and get all of the benefit of the oiled foam filter without spending any money.
  13. R

    Leaking Axle Swivel Ball

    Did your installer fill the knuckles with grease or with gear oil?
  14. R

    squeeling power steering

    Lookup the msds for downy, see what's in it, and then decide if you want to put it in your power steering system.
  15. R

    I determined my CC bushings are in wrong!

    When I first deciphered the OME instructions for installing the bushings (install front bushing with hash mark down [note: edited to state hash mark is to be down on front bushing] and perpendicular to a line horizontal to the chassis), I logically concluded that their procedure does not result...
  16. R

    I determined my CC bushings are in wrong!

    Based on above you pretty much have all the castor correction you are going to get. Minor changes in the alignment of the bushings from what you already have are not going to make a major change in the total castor correction.
  17. R

    Rear (Spare Tire Area) Mount Tranny/Oil Cooler Questions

    More cooling is better only if the original engineering is wrong, or for some reason you heat load your truck exceptionaly more than engineering planned for. Either of which could be true.
  18. R

    EATON M90 vs 1FEFZ ENGINE

    The roots of the TRD supercharged Land Cruiser:
  19. R

    Hood spacers, gave it a try.

    If air gets pushed into the engine compartment from a high pressure area at the base of the windshield, then the additional pressure in the engine compartment will reduce the airflow through the radiator, reducing the efficiency of the radiator, with a likely increase in engine temperature...
  20. R

    voltage/idle fluctuation

    You are replacing your alternator because the engine idle varies when the turn signal is on?
Back
Top Bottom