Pics of Trac Bars
If i was you i would re do the spring perches at a better angle it looks like its angled way too high and that can cause problems with u joints and whatnot :'(
well ive been thinking about it for too long and now I have to figure out what the hell Im doing with this project
so I have a 307sb, a lakewood scattershield set up for the toy 4spd and a 71 landcruiser to put it in ,I need some alternatives to the back of transfercase style crossmember (dont...
just picked up a 69 1ton chevy with a 292 and sm465 and in the specs in the manual it makes 275ftlbs @ 1200! and 170hp@4000 thats pretty damn good for a cruiser
the 250 however would likely be a little less just cuz its smaller
the bellhouing bolt pattern is the same as a small block v8 even...
I want to know how big of tires can be run on a 40 with Spring over a smallblockv8 4spd and 72 tcase with 4.1 axle gears and I also have fj60 birfs if that helps at all. I was thinking 35sx but i see lots of cruisers on here with 38.5s how do they hold up?
I know that on the street it would be...
I did it on the frame and then took it off flipped it over upsided down and did all the bottom stuff like rock sliders and body supports
get a bunch of c clamps they really come in handy
heres a pic of the bottom of my tub after primer and undercoating
In progress
when I rebuilt the tub for my cruiser I built rock sliders into the tub sides I used 1/8" steel for side peices which come up to the bottom of the kickvent and sqaure tube on the bottom also reinforced to the body crossmember and body mounts and the 1/8" floor!
check out the...
so I am almost finished my frame off resto and the my 76 2f motor turnes out to be pooched! the fuel pump diaphram broke and ran lots of gas into the oil and wrecked the mains ??? I was changing the oil and it pissed out probably 15 litres of gassy oil
350 time!
anyways when I bought all my...
But the thing is I have never seen a 55 or even heard of one in b.c. and I have some 60 series springs in my backyard?
are fhe fj 55 springs using the same bushings and pins as the 40 series??
Other than the difference in bushings and bolts on the 60 series springs would they be a good swap in a 40 with soa to get some more wheelbase?
Has anyone tried this??
I was thinking about switching the stock f carb on my 2f I saw an adapter with a holley 500 on it for the f or 2f
would that be worth getting or is the holley junk compared to the stock aisin units?? the things I would like about it is I could have a nice dish type aircleaner assy and a rebuilt...
well I have ran the motor before but never driven it the oil looked normal before I started running it
i put 5bucks gas in the tank ran it for a total on 15 mins and then it ran out of gas ???
put more gas in and run it for a bit then go to change the oil and its gassy oil ???
I know that...