My carburetor number 60191, manufactured from 3/69 to 9/69 has a solenoid on it with one wire cut.
After the engine is warm it's a little cranky to start.
Seems like it's rich and I have to open the throttle plate gently a little to start.
Where does the missing wire go?
I see a sensor on the...
Had four rust areas on both sides on the door sill. Rust areas were between the door sill gusset and the outer sheet metal.
Cut out the rust, neutralized the rusted gussets, welded in new sheet metal, primer and filled.
Getting ready for the paint & body shop.
I need to replace my inner wheel well brackets. Can't seem to find these and not interested in fabbing if available. Any suggestions?
These are the brackets below the wheel wheel where the seat bolts go through.
Having viewed the various posts on this subject I'm giving this repair a try.
I've ordered quarter panel patches, rear sill from Cool Cruisers.
Expecting parts this week.
Thanks for looking!
Searched posts on best way to removal my steering gear box to replace it with a rebuild. Is there a good post on this (pictures helpful), I can only find rebuilding the box?
My repair books only show the later styles.
My tube connects directly to the gear box and I'm trying to separate them...
Trying to figure out where I have a disconnected wire under the dash.
Power is good to the column reverse switch.
Power is good from the column switch when in reverse.
Loss of power between switch and right engine compartment connection that goes to the rear backup lamp.
When I provide battery...
I'm looking for PN: 37410-60010 Joint Assy w/yoke to finish my OEM winch set-up. New or used.
Thanks for looking Bob.
See item 37611 joint on attached schematic.
Bought this winch, pto and drive shafts. Not sure how this all goes together. One gear case mount is broken, output worm gear shaft yoke is welded. Brgs and seals need to be replaced on worm gear shaft.
Paid $500 then opened it all up. Ops!
But besides all this how does the drive shaft go...