a vacuum leak here will almost drive you to the funny farm trying to find it.
does anyone know a part number for a
O-Ring part number in IAC in 91 Land Cruiser 3fe engine
Intermittent problem
truck runs great nice power....then decides to start hesitating from 2000rpm to 2500 rpm sometimes a backfire..... then takes off like a rocket once it hits about 2500 rpm.
also when this hesitation starts it will start idling badly.
it will do this if cold or hot...
i am testing my idle air control valve. FSM says apply power(+) to the 2 middles terminals and touch ground to other terminals. valve should move up and down. when i touch them the valve just pulses....no movement......so i bought another one.....did the same thing....pulses...no...
1991 cruiser has no spark....for three months
replaced everything that makes a spark
new igniter
new coil
new dizzy
new computer
new wire, cap, rotor, plugs
new fuses
new relay
new ignition switch
checked all wires over and over and over again
error code is 14
"no IGF signal to ECU"
toyota...
i am getting 12v @ e1 to +B terminal on ECU
i am getting 0v @ e1 to +B1 terminal
i am getting 12v @ e1 to BATT terminal
i am getting 0v @ e1 to M-REL terminal
i am getting 0v @ e1 to IG SW terminal
i am getting 0v from +B1 terminal straight to ground
i am getting 0v from M-REL terminal straight...
ok here goes
1991 land cruiser
had a after market alarm installed but i removed it and it was running great but there were no gauge lights working. i figured i would get to that later. so tried to fix the gauge light problem. removed driver side kick panel. also checked wires coming from dimmer...
i get this vibration no matter what (acceleration or deceleration) at between 30 and 40 mph......does not matter what gear........could this be drive shaft?
HELP!!!!! i have a bad steering gear leak. wondering of it is worth it to rebuild it or just get a new one.....i am pretty sure it is the top seal......is there a way to change just the top seal? and how easy is it to get to?
can anyone post a picture of a WORKING oil pressure sending unit on a 1991 3fe engine? that is the only gauge that does not work in my cruiser. thanks tons