wagonteeth

Two things Y You need a functional OD light to read the AT cods you use a jumper in the OBD connector and count the blinks And I used Isuzu solenoids 60$ for the all 4 2x Isuzu 8-97202072-0 Transmission Solenoid 1x Isuzu 8-97202073-0...

Used aftermarket glass from whoever bought ppg a few years back. I did as above and supplied oem gasket. I also printed the windshield install pages from the manual amd told him it needed to be done that way. Sealed in amd out and no leaks. Glass...

Whole Lotta nice. I dig the redarc gauges. I look3d and couldn't find a dual with egr and boost. I may have to reconsider. How different with the new turbo and intercooler vs. Stock? I'm guessing dramatic. What boost did you settle on with the...

Theres a trade off between high clearence and coverage, for me its moot to have such high clearence when you have things hanging down explosed right behind it. (e.g. The obvious AC Dryer) I was torn between Slee, 4x4Labs and ARB. I went with...

Here's a couple of my front 4x4labs. It has extra light mount tabs added. I'm an ARB fan but this is pretty solid and better approach angle

Just bought a ds seat cushion from Japan. It got to me quicker than a part I order from Florida.

Yep, look inside the wheel hub hole. There is likely a lip that raises a few mm and its there to retain the center cap for the wheel. This has to be machined iut to work on an 80. Chek your front too. The lip would just be touching your drive...

Go to ppartsouq.com and enter your Vin Itll give you all of the part numbers and you can cross reference on us sites as needed. I often just get the p/n and paste then add "toyota" to see what Google comes up with. Window rubbers are the same...

Gonna do my best to attend. Meeting at the trailhead? And is this a rain or shine event?

It says it's for 100, 200 and 300 series. Are 80s welcome?

I just missed the March meeting, but would like to show up for the mid March ride in north Ga. Is this still on?

If they were open box, there's a fair chance someone got heavies, found them too stiff and order 860s and returned the 864s in the box. If Noone beats me, I'll measure my 860 diameter and post. They're on the truck so can't give you oal

Yeah 1.5" is what mine were.

This is the first time I have done this so there may be a better way, the following is just the way I did it. The part numbers I am showing is for a 1993 with manual controls and cloth interior. 71512-60020 is the driver seat and...