I built my own J pipe based on the Witsend and other custom built ones before HD auto made the kit. Cheap to build if you have the skill to do so or a good mate. I run the Pulsar GTX3582 which has very good reviews from many aussies using it on...
Haha, I drove it into a rock.
I was creeping down the trail looking at a map instead of the trail. Goodthing I was only going turtle speed 🤣 I still had to use the front locker to back up.
Other than that I used it to get where I wanted to...
Over the past month due to broken bolts, seized parts, and parts on back order from Toyota. Finished up the rear axle and parking brake rebuild, Landtank extended rear lower control arms, Dobinsons adjustable rear upper control arms, Dobinsons...
Just the generic steel beadlocks and cooper stt pros. I drag them across a lot of rocks. A lot a lot, so I feel better about it than aluminum beadlocks
Pyeatt Draw/ the filter. I did pull cable and setup but did not end up needing it. I wheel...
Power and solar distribution relocate under the hood
New front grille with turbo badge for incoming install
Mountain hatch tailgate panel to replace carpet
New oem carpet
Rework of in cab electronics and drawer system…
Modified the front hubs for a 200 series rotor/150 series caliper upgrade as @Dirty Koala did it.
Used an old 1" spacer to keep it all together while test fitting. With the spacer on there it'll even work with 16" OEM steel wheels.
analysis paralysis has set in…this is part of the rear of my home made drawer system…still has the inverter and viair compressor to install but I keep second guessing what I want to do…this is falling under the while I’m in there realm…
Damn that looks nice, same oak color and mine looks like it’s 27 years old. Better add this the my wish list.
I replaced my speedo gear o-ring and cleaned up the mess on the T-case, must have been leaking pretty bad since I added 3/4 of a...
Today was new carpet install day…my favorite day said piglet…
Naturally you don’t just rip out the carpet and put in the new…many little while I’m in there tasks were completed…
That said Toyota sure covers the bases with thier parts…this carpet...
I put a new pipe in whole with the body on.
I compressed the pipe from being round to an oval. Then jacked up on the rear floor for extra room and forced the pipe in. Then using a c-clamp round out the pipe again. The pipe interfaces with a...
Woah dude, 600?!
Yep, I gotta get megazip on there. It’s on my list once I get a few things cleaned up.
A feature I have planned is to allow for searching multiple parts at once to get full cart price vs individual part price. So you could...
There is discussion of the 105 steering gear box in a Toyota engineering book I have at home. They were not talking about it in LC speak per se, more in engineering terms for FMEA purposes.
The stated reason was due to research and feedback...
Boost and AFR is what I run in my 80 on the A pillar with two pod autometer pods. The wires are really easy to tuck behind the pods
Had some custom units made up for a client. Went with Boost and AFR. They turned out great.
Another truck...