x

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

IIRCC front motor brackets are the same 55-40
rear bellhousing brackets are different as they used different isolators 55-40

but being a V8 the PO may have cut the brackets off the frame for clearance
 
Looking at the parts diagrams for both they are different then the 40 series. Part numbers are different too. The FJ55 the front brackets look to be riveted to the top of the arch that is over the front axle. The FJ40 is on the back side before the top. The FJ55 shows a flat section across the top while the FJ40 is a arch. Being forward makes sense since the FJ55 grill is closer to the bumper and front spring perches. To add a factory PTO winch to a FJ55 you need a extension kit for the frame.
 
I expect the mounts are cut off and gone.

It sounds like I may get lucky with at least half of the mounts by being able to get a front set from a 40.


Probably 2/3. The left rear is still only a plate on top of the frame so good chance it's still there. Wouldn't be the first time Toyota gave the same part different part number. I know the late model rear motor mount L bracket got a new number in 10/82 with the start of the five speed option. Have L bracket before and after. Both stamped with the same FB plus two numbers.
 
Those appear to be welded not riveted. Interesting since they are a separate part according to Toyota would have thought they were riveted. When the 60 series rear motor mount L brackets started to be welded to the frame the part number discontinued.
 
Back
Top Bottom