Work Truck Build Up

[Deny]

I’m leaning towards cutting the dump frame out of this truck and eventually putting it in the farm truck that is in the works right meow.

 

[Deny]

man There are so many tabs needing to get built and welded to axle and frame!

 

[jfc]

Fantabulous

 

[Ratpuke]

Just need to weld a squeeze on the back of the flat deck and you can tip them stubborn ones up with the dump

jim, you’re alive?

 

[jfc]

So far, Wu tang flu ain't got me yet

 

[BC40]

whats new? looked like some good progress there.

 

[Deny]

Ha ha, not much, that's pretty much where it stalled. I started doing a few things on my current farm truck build (ill start a thread on it eventually when I get some progress pics from Dan and I have some time), then outside got nice and busy on the farm, and now work got busy and I have a bunch of reclamation work I need to take care of. I will probably get back on it next winter.

 

[jfc]

Still stalled?

 

[Deny]

Pretty much. I did a little bit to it before Christmas, but nothing to write home about

 

[BC40]

looked at the start of this thread. hard to believe its been 15 years

 

[Deny]

yeah, I think if it was a 40 series I might have more motivation to work on it, right now I prefer to do stuff on the farm, which keeps me pretty busy as well. I think if someone came to me with a solid offer, I'd probably sell it as is.

 

[Deny]

So been plugging away at this thing a little. I’d like to put it together enough to get it to start and drive onto a trailer when I sell this thing

 

[Deny]

Few more of the progress of patching inner fenders so I can put together the front clip with paint on it in case it goes outside for a bit and won’t rust

 

[Deny]

Exhaust check

 

[BC40]

So been plugging away at this thing a little. I’d like to put it together enough to get it to start and drive onto a trailer when I sell this thing

you really should keep it

 

[Deny]

you really should keep it

Ha ha, I should with the amount of man hours I got into it, and it would probably be pretty fun to drive with the front coils, turboed and intercooled 1HZ. But I think I prefer the 40 series

 

[Deny]

Did some painting. And installed the finished drivers fender a while ago

 

[Deny]

Then I installed rear driveshaft and swapped out mine passenger door for less used one I got from Brad Taylor when I was in Saskatoon getting parts many moons ago

 

[Deny]

Speaking of Saskatoon, pulled out and dusted off some bling bling I got from Ens Toyota on that same trip

 

[Deny]

Continued plugging away at things. Once front clip dries, I’ll be putting it all back together and hopefully starting it up!