Wiring

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 7, 2004
Threads
23
Messages
1,019
Location
Eastern PA.
I got my 74 wiring almost done and have everything but the back heater working(cause it's not in yet) and have this wire hanging next to my coil. It's black with no stripes and doesn't seem to get hot with any switches on the dash.

Any ideas what it is?


Thanks

Kevin
 
Try taking an Ohm meter and wringing it out against the fraem (Se if its a ground) May be a lug to go on the base of a component to ground it
 
On a Chevy, and I believe the cruiser also, there's a hot wire that bypasses the resistor during start up on a points type ignition. Because your voltage dips down during cranking.
To find out check it while cranking thats the only time it should be hot
Does your starter have two small wires connected at the selinoid?
If that is the case it should bolt up to the same place on the coil as the resistor
 
I checked for continuity to ground and there wasn't any. I thought something was jumpered off the coil power line so I hooked it up there and still nothing (still ran fine).

It's part of the harness. It will reach the coil but is too small for the coil mounting bolt for ground.
I haven't checked to see if it will fit the apron mounting bolt.

Kevin
 
pontiota said:
On a Chevy, and I believe the cruiser also, there's a hot wire that bypasses the resistor during start up on a points type ignition. Because your voltage dips down during cranking.
To find out check it while cranking thats the only time it should be hot
Does your starter have two small wires connected at the selinoid?


I didn't check that. I'll try that next.

Kevin
 
The crimp-on ring terminal is definitely "aftermarket," so there's no guarantee that it is original to the harness. If it were a ground wire it would be white with a black stripe. If I were to guess, though, I would also say that it is the bypass wire from the starter solenoid to the coil (which would attach to the coil terminal opposite the little black wire going to the condenser on the distributor). If you have a black wire just the same gauge coming off of the starter solenoid, that is even more likely. If your battery and the rest of the wiring is good you probably would never notice if it was attached or not.
 
Maybe it was for the Ignitor which I did not see in your photo.
 
I think ignitors showed up in '76. A tachometer wire would definitely show up there.
 
pontiota said:
On a Chevy, and I believe the cruiser also, there's a hot wire that bypasses the resistor during start up on a points type ignition. Because your voltage dips down during cranking.
To find out check it while cranking thats the only time it should be hot
Does your starter have two small wires connected at the selinoid?
If that is the case it should bolt up to the same place on the coil as the resistor

That was it. 2 wires off the selinoid, one is black.

Thanks

Kevin
 
Back
Top Bottom