Windshield vendor

[dfarley4504]

Not sure if this is the correct form, but I’m looking for a shop that can cut & install a windshield for my 72 FJ40.
In Florida between West Palm and Vero beach.
Thanks

 

[MDH33]

Do you have the old one for a template? If so, any glass shop can cut one. You'll need the weatherstrip but they're available., I had a tractor repair shop make mine. It was cheap.

 

[TimMc81]

Do you have the old one for a template? If so, any glass shop can cut one. You'll need the weatherstrip but they're available., I had a tractor repair shop make mine. It was cheap.

did they install it for you? I can see daylight through the upper left corner of my windshield. The seal does not reach the lip of the windshield frame...

 

[tpclassic]

I guess our windshield would fit your and you don't need to cut anything: Windshield Glass, for FJ40, FJ45 Toyota Land Cruiser 1975-1984 (Local - https://tpautoparts.com/products/windshield-glass?_pos=1&_sid=62513cbd6&_ss=r

 

[MtnAddict]

Will glass shops do the install as well?

 

[tpclassic]

We are not doing installation but all windshield installation should all be the same -- you can get support form local auto glass shops I guess.

 

[tpclassic]

Will glass shops do the install as well?

I am not sure. What I really mean is that if the H channel rubber seal is available, installation should not that hard.

 

[MDH33]

did they install it for you? I can see daylight through the upper left corner of my windshield. The seal does not reach the lip of the windshield frame...

Yes, they did. Ithink it was about $200 installed plus the gasket which I got from a mud vendor.

 

[TimMc81]

Yes, they did. Ithink it was about $200 installed plus the gasket which I got from a mud vendor.

Wow, I think I will get a gasket and take mine to a windshield repair place. I don't have four hands to hold the windshield and seat the gasket, and I really don't want to put clear caulk in the gap that the PO left between the gasket and the frame...