Where to tap power?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 6, 2003
Threads
186
Messages
3,183
Location
Tulsa, OK
I'm adding some lights, and I'm currious where I can grab some ignition on power by the switches on the left of the locker switch. Doing relays for juice from battery, so I"m not worried about alot of draw, just enough to actuate the relay. Is there a common easy wire to tap?
 
Walking,

That is pretty close to the inside fuse panel. If you own a test light ($10 at parts store) you can probe for one at the panel, and see the circuit it represents on the panel door.

To further identify a good donor circuit, you could download the electrical portion of the FSM. Of coarse I would advise getting the whole manual "while you ae there".

I realize this does not directly answer you question, but hopfully helps you some.

D
 
BLU/BLK at Diff lock switch is ignition (hot while cranking) it is protected by the 30A fuse in the left underdash fuse block. Depending on how far you are running the wire you add for your relay, you should fuse it with a 1A or smaller fuse at the point you tap into the factory wire.
 
Last edited:
The easiest way to tap Ing. power is install a piggyback fuse in the cig lighter location.

Littlefuse add a circuit or other similar product will do the trick.
2 minuets and 10 bucks....


ken
 
Back
Top Bottom