What would you do?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 25, 2005
Threads
41
Messages
156
Location
Bradenton, FL
I am awaiting delivery of my HFS 4" lift and 1.5" shackles and have run into a decision that I am having a hard time making. I can run 33x12.5's and not cut the fenders or cut them and run 35's but.....my fenders are rust and dent free. There lies my issue, would you cut perfectly good fenders? BTW This is a daily driver of 75 miles daily on potholed, washboard, lumpy rock roads in Costa Rica.....very little asphalt time.
 
Gotta agree with Mr. Poser on this one. Unless you want to send me your nice fenders and I'll send you my dented rusted ones. Then you can trim away at will and not feel any guilt.
 
I had to make the same decision and decided to go with the 35's and keep the rears uncut. That way I still get the 4" lift and a significantly larger tire than the 31's that are on there now. I'm going to go with the MAF Safari shackle reverse kit. In the end I just couldn't cut perfectly good fenders, especially on a 79.
 
Have you priced a non-rusty fender...keep 'em uncut or change to fiberglass and cut 'em. You won't have any problem selling your steel fenders on the board.
 
Is there no way to run 35's on that setup with out rubing if you dont cut ur fenders.
I have the same setup with 33's and they have never ever come anywhere close to rubing even by 2 inches!!
 
Kroozer- I have done a ton of searches on that subject and have got mixed opinions....some say they will rub the inside of the well and others mashed their fenders. Are you running the 4" HFS lift with longer shackles?
 
Back
Top Bottom