Wanted WANTED ====> Exhaust Manifold Insulator Front for 2F <====

[In2cruisers]

Vehicle Model

1. 60 Series

Looking for a exhaust manifold hot air riser for a 2F smogman wont pass without


something like this

 

[In2cruisers]

Beuler? Beuler?

 

[wimberosa]

Very very scarce. You'll almost assuredly have to make one. Many people do it different ways.
Here's my example:

Build Post in thread 'Wimberosa's build: Loretta dances again'

Jan 19, 2025

A few posts about what NOT to do...

Don't build an intake preheat flange like this. I started out with 14 gauge 3"x3" square stainless tube.
I decided to pie cut the tube to produce a 90deg bend. To do that was super fiddly and took loads of
time. Really just cutting two 45s and welding the two legs together would have sufficed. However,
I suspect this will never fit in a general manner if you have power steering sitting beside this flange or
your exhaust manifold wings are aligned slightly different. The manifold joint for this front wing is also actually
slightly bigger than...

• wimberosa

• 

 

[Texican]

Reckon over near 40 years of LCDS {Land Cruiser Derangement Syndrome) I've thrown a dozen away.......

 

[Okie_dave]

I have a crappy one from a 60 if you still need it

 

[Toyrod]

I have a nice one that I believe is from an 82 FJ60. I can get a pic Friday when I'm back in town

 

[Toyrod]

 

[wimberosa]

That is a super nice one! Wish we could turn that over to someone who could fab us more. Its a piece that gets
asked for with little supply.

 

[3_puppies]

View attachment 4021560View attachment 4021561

that is a fine example of the 70's version of the part
not sure it works with the stock PS pump on later 2F's
I've never checked if it will fit on later 2F's

 

[65swb45]

That’s a 75/76 single piece manifold shield.