vapor lock?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 18, 2006
Threads
14
Messages
45
Location
mississippi
i just got my first fj40. it is a stock 72 except for the holley carb, as far as i can tell at this point. i have been reading other post about hot start problems and think mine is do to vapor lock. starts fine cold, but will not start hot at all. i tried it with the gas pedal to the floor, but no luck. when trying to restart the starter quickly begins bogg down. though it will start and run fine if i roll it or pull it off. any thoughts?
 
do a search on it there are some good threads in hear about it.

jsut go down to your local craigen, auto parts store and buy some heat sheilding and wrap it around the gas lines running close to the hot motor. Problems solved. make sure the fuel lines are away from the headers adn exuast where it gets really hot.
 
Welcome.



I would first investigate the condition of your battery, the cables and connections at the starter solenoid and battery. You will likely find one or more components in a questionable condition, which will cause your starter motor to bog down as you say.

As far as your suspicion about vapor lock is concerned, thermal wrap can help, but will not do anything to help if the system is not vented and plumbed correctly. It is not uncommon for people to install the wrap product and have it do nothing to help remedy a mis diagnosed problem. How are your fuel lines routed, both from the tank to the pump, and from the pump to the carburetor? Are you using a mechanical or electrical pump? Post up a couple pictures of what you have going on.



Good luck!


-Steve
 
Great thread. I have the same issue. Also check for the, forget the name of it, valve in the exhaust that is meant to warm the carb with exhaust at start-up. I know mine is stuck open and cooks the carb helping to creat this problem.
 
bigsandy,

Welcome to MUD!

You mentioned a Holley carb, which is not a factory piece, so you have some PO mods to decipher. Some years of 40's had a fuel return line.

A good resource is to get the Emissions Manual for your rig. Examine the vapor return system/charcoal canister, etc...

Also, I think TreeRoot had an issue - what happened to this?
 
I still have issues...I unplugged the vent/return line (was blocked off) and that fixed a lot of the problems I was having. In the process of troubleshooting, I added an electric pump behind the mechanical. I think it is cavitating the fuel before going into bypass. Possibly because it is too high of a pressure. I'll remove it and see what happens now.
 
Back
Top Bottom