Valve Adjustment- Quick Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 8, 2003
Threads
8
Messages
28
My question is - when I rotate the engine after adjusting 123579 how much do I rotate the engine to adjust the others. Do I rotate until I see the TDC mark again and have the rotor point to Wire #6 on the Dist. cap. or do I continue rotating until the rotor points to the #4 plug/#1 wire (this would mean I pass the TDC mark once)? If it is the 2nd, then I have to re-adjust valves.

Thanks,

Scott
 
360 degrees....one full revolution of the crank/flywheel. Start with the flywheel on TDC, adjust whatever valves you can(123579 or 468101112) and then rotate the engine completly 360 degrees, and adjust the ones you did not do previously.


Good luck!


-Steve
 
PabloCruise: Then, start counting from the BACK of the engine, and adjust 123579

I love math tricks!

Dork.

...


But I'll use it. I salute you. :flipoff2:
 
Back
Top Bottom