Vacuum hose help? 3FE

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 11, 2005
Threads
29
Messages
388
Location
Seabeck, WA
I just noticed this today. There is a vacuum hose missing from this connector. I looked all over the engine compartment, don't see anything dangling. I can't find a good pic in the FSM. The vacuum hose sticker under the hood may help if I knew what I was looking for.

This is right on the intake hose going over the engine from the air filter....

Can someone with a 3FE tell me where this should go? Or point me to a good drawing?

Thanks,

Rich J



 
Last edited:
Sorry for the late response...I checked this post earlier but had to go out to the field.
That hose runs down to an LSPV sitting just in front of the charcoal canister. I can't ever remember what those dohickies are called as I am an idiot w/ vacuum.

Wish I were more help-I may try to get a pic in the morning for ya
 
richj11 said:
Well, at this point I'll take any tidbits I can get. I found a vacuum diagram on-line that may help, just need to trace everything out again and see what is missing where.

Rich


I was going to do this in the mornig...but your pulling at my heartstrings man!

I can't have a 3fer stranded...
vacuum2.webp
 
Thanks for the pic! Unfortunately, that is where the top hose in my picture is going to! :doh:

Actually, I found a diagram (@ Autozone.com of all places!) and it shows one of those hoses going to the VCV, which I think is what you have in your picture. The other goes to the top of the air filter. I'll need to get a closer look in the morning and see what is on the other end of these and if it matters which is which.

Thanks for the help!

Rich
 
Rich I tried to reply but my cpu ate the message, the upper hose goes intto the upper port just to the right of your pic, the middle hose goes to the little doo hickie.......
Dave
 
Thanks to those that contributed to my plight! I got a look this morning and there seems to be more problems than just one missing hose. A couple are not going to the right places...

It seems to be running fine, but we'll see when I get it all straightened out.

There is not just one definitive vacuum drawing. It will take correlating a couple different schematics in the FSM to get this right. That and some new vacuum hose that will be on the way from CDan soon!

Rich J
 
Back
Top Bottom