trouble with driveshaft?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 8, 2005
Threads
23
Messages
78
Location
Victoria, Australia
Hey guys! I know this is probably not the correct section as it's not a cruiser but it does have a lot of cruiser stuff on it and I'm hoping someone can help me out here. (Landcuiser guys always seem the most cluey about these things!) I have a 86 Hilux with a 350 chev and T350. Lately it has been making a high pitched 'warbling' sound at around 60km\h, almost like a loose belt sound. If I keep engine revs and speed constant and knock it into neutral the sound stops. I was thinking bearing in the transmission but it was reconditioned only 7000km ago. The sound isn't there all the time, and goes away if I accelerate hard or over about 70km\h. On a different question, I also have a new shudder in the truck when I take off. I recently had new tyres put on (Mickey Thompsons 35's) and had everything balanced (2000k ago) and it was running smooth. I was going to take the rear driveshaft off and run it in H4 with just the front driveshaft to see maybe the rear had thrown a weight or something. My question is are there limits to how far or ast I can run in H4 with only front? Am I going to do any damage to it? Any help would be greatly appreciated
 
No problems running in H4 with front only, I ran a NP205 like that for 3 months back and forth to work(65 mph both ways). BTW, just cause the trans was reconditioned a while ago does NOT eliminate it. I would say that is the problem, front end of the tranny. (and i dont mean a lady with a pecker, of course that is always a problem too)
 
lol! Took the driveshaft off and although the u-joints look fine, I packed them full of grease and the sound and vibration went away for the first minute of driving and then came back so I might just change them over and see if that helps. Thanks for all your help.
 
Back
Top Bottom