tranfer case stuck in 4 high

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Mine is really hard sometimes. I have to back up for about 50ft then put it in 1st and let the clutch out slow until it moves.
 
Assuming that you have a shift lever that won't move properly and not a vacuum actuator, get underneath and pound on the end of the 2w/4w shift fork rod. you can identify it because the linkage fits into a slot on the end.
If this works, you might want to lubricate the shift fork rod.

PS. It helps to post what year and model you are talking about so we don't have to guess.
 
I have the same problem on my 79 40 sometimes, just try going reverse for a few feet and then while in reverse, with the car stopped, try to shift it then.
 
I had the exact same problem on a '78. Tried all of the above fixes to no avail...so I rebuilt the t-case and found the front output bearing was shot and chunks were in the case, locking the shift fork.

My advice...drain the t-case and use a magnet in the fluid and see if you find anything.
 
joesfj40 said:
try s***ing while the cars moving a lil bit :)...



This technique is not recommended.:D


ed
 
just thought of something.
wouldn't jacking either the front or the rear axle off the ground (neither tire touching) alleviate the binding in the case?
(actually.... unless you have a locker, wouldn't this also work by jacking a singe tire off the ground? the open diff would let the binding force slack off through the lifted tire right? Anyone?)

kind of drastic, but it would elliminate *transfer case bind* as the problem I guess.
 
you could raise the whole rearend off the gound and have someone slowly turn the rear driveshaft by hand, as you apply pressure to see, but my guess is - if it won't go in now, that won't be a solution. The other possibility is that the shift rod is rusty.

When's the last time you were able to get it in 4wd?
 
Yes, try the easy stuff first. Unlock the hubs and tap on the shift rod with a hammer. If the hammer works, you will probably want to take the fork housing off of the front nose cone and lubricate the rod and replace the seal and boot. Your next step will probably be taking off the housing anyway if it resists the hammer, but it could also be a linkage problem.
 
Isolate the shift linkage from the tcase.


I would bet that the pivot that the shifter arm rides on(the linkage part, not the tcase part) is frozen, preventing anything from moving.


After the tcase linkage is no longer connected to the shift arm on the top of the tcase, put a large vise grip on the lever and swing it/move it towards the tranny...as this will give you neutral and then one more detent position will give you low range.

Doing this will also prove that this is not a tcase issue, but rather, a shifter issue.

You can take the shifter off and make them work again easier when they are not on the truck.


Good luck!


-Steve
 
Have you ever greased the shift lever?


There is a zerk on the bottom of the shift lever....


If you cannot get the truck into 4wd, again, isolate the linkage from the tcase, and then try and manipulate the front drive acctuator with a vice grip..


Good luck!


-Steve
 
Back
Top Bottom