Trailer lighting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 20, 2018
Threads
6
Messages
62
Location
Oregon
Has anyone ever seen a trailer lighting socket like this.. Or the plug that goes in it?

IMG_20180705_161958.webp


IMG_20180705_171017.webp
 
It only says "made in USA" on the lid. So it would seem that the bumper, or at least the socket was added sometime after it arrived from Japan (in '64)

IMG_20180706_071041_01.webp


IMG_20180506_140940.webp
 
There is also a very common plug used during the sixties and seventies that has six pins that would probably fit the hole. Both my 68 and 70 the original owners drilled the sill to mount them.:bang: Wouldn't be too bad if I needed to replace rusted sills but both these are rust cruisers. At some point will need to have the piece welded in. I have switched to the common flat four pin trailer light plug bolted to a excisting hole in the bottom of the rear frame member.
 
Back
Top Bottom