Tool for front hubs...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 25, 2005
Threads
205
Messages
1,768
Location
Hagerstown MD
I need an oversized socket, 2 1/8" seems to be the closest size for the front hub nuts. I used to see pressed steel sockets around for 4wheel hubs in the old parts stores; are they still around? Napa? Sears has a 3/4" drive deal for 30 some beans but of course I'll need that adapter too. Additionally, I think the wall thickness on the sears socket maybe prevent it's use. Frankly I HATE 12 point sockets.

Any solutions other than the SOR tool? I was told it works about 5 or six times and is then headed for the s***can. Cheap is good sometimes however I'm not wanting to track down the Snap On guy either.
 
IIRC the disc brake spindle nut is 54mm....

Better NAPA stores that I have been in carry OTC sockets for larger truck spindle nuts....you may get lucky there....




Good luck!


-Steve
 
The SOR tool works pretty well. What I found is that you can't use it to REMOVE the nut (tap the corners with a drift pin to spin it loose) but it works well for tightening it. I now have the proper size socket, so I haven't used the SOR tool in a long time. I do recall that I would bend it out of shape if I tried to loosen the nut with it.
 
Was this tool a six sided socket out of stamped steel? I am in need of something to set the load on these bearings tomorrow.

What is the recommended procedure (the best method) for torque on the front wheel bearings? thanks for you answers and input here guys KC
 
not napa

you wont find that socket at Napa or any of the chains, I tried and tried. I bought mine at a local tool shop. It is the stamped steel socket and very tough. They had to order it for me ,so someone out there is making them.
 
fj40greencruiser said:
you wont find that socket at Napa or any of the chains, I tried and tried. I bought mine at a local tool shop. It is the stamped steel socket and very tough. They had to order it for me ,so someone out there is making them.
not normally but i got lucky they had a table everything under 10 bucks and i picked up 2.:D
 
I bought my 54 mm OTC at our local NAPA store for about $12.00. It works fine for removal and installation, and I wouldn't put enough ooomph on one of the axle locknuts to bend the socket.

soul man:"The SOR tool works pretty well. What I found is that you can't use it to REMOVE the nut"

Soul man,
Do you think that maybe when you went to remove the nut with your socket you inadvertently let the socket slide in enough to catch both the adjusting nut and the locking nut at the same time? That's about the only way I can imagine having a problem such as you describe. You'd be twisting against the ears on the lockring.
 
Back
Top Bottom