Tips for how to replace the front rotors?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 26, 2004
Threads
116
Messages
1,282
Location
Oregon
Website
www.brian894x4.com
Quick question on replacing the front brake disk rotors. What's the easiest methold to remove the disk from the hub? And then reinstall the new disk. The book shows putting the disk in a vise, which is not exactly my ideal method.

Any suggestions would be much appreciated. Need to tackle this tonight and tomorrow.

I assuming I can just break the torque with the hub and disc still on the spindle, maybe using the calipers to grab the disc and hold it in place. Not really sure how to torque it while it's off the spindle with the new disc.
 
Last edited:
Just had this thread last week ;) While the hub and drive plate are still assembled to the axle, simply remove the rotor to hub bolts. It is just like removing the lug nuts, but easier. When I put the new rotor on, I bolted and "hand" tightened it off the axle, then finished torqueing it when it was on the axle w/drive plate.
 
In my case the hub and rotor were a bit seized up, not bad, but would not come apart by simply removing the rotor to hub bolts. I did put the disc in a vise and gently pried around with a pry bar and wiggled it off. Putting the hub on the new disc was easier than I thought it would be to get lined up. Went on like butta.
 
You have an air impact? If so loosen them with that. If not cut a 2x4 to fit between the ground and one of the studs vertically to keep it from spinning. Loosen it that way and torque it down the same. Easy, did it 2 weeks ago.
 
Back
Top Bottom