Thoughts on removing the LSPV?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Me thinks it would be tail happy in slippery conditions.

I asked my mechanic about that as well (4 wheel disc here..) and he told me that it would be a bad idea as you'd get full force rear braking all the time. Unless you installed something like the wilwood brake proportioning valve at the same time.
 
While I agree this is probably not a good idea, it wouldn't be all-bad, all the time. Since it's a load sensing devise, it would probably only affect the brakes when under load (or if you otherwise modified the suspension as in adding lift). I personally would not want to have to worry about poor brake performance when you likely need it most (under load)...
 
it would probably only affect the brakes when under load

Under load, it applies more brake force- so in essence you'd be driving around with 'load' type braking all the time. It would eat up your rear pads. Sure when towing you wouldn't notice it, because that is what you'd get anyway.
 
I still need to raise mine.
But seriously, I have not really noticed the difference but I guess I just have a 2.5 " lift. I expected it to be more sever.
 
I replaced my LSPV on a prior FJ62. I used the T junction and rear brake hard line from a non LSPV FJ60 series. This worked out well in that situation. I too have to adjust mine.
 
Being rear drums, I don't think I'd have the tail happy feeling you disc guys would get. I also feel that this will make things more trail friendly where even loaded down, a descent unloads the rear end making the rear brakes very weak.

I think I'm gonna go ahead with this, and if it feels sketchy I'll just put the PV back on it.
 
I ruined mine on the trail. I came down off a stump onto it. Wiped out the rear lines as well. I just replaced it with a Wilwood manual proportining valve and ran new lines to the rear.
 
Back
Top Bottom