Thermostat question. Is it open?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 25, 2014
Threads
8
Messages
36
Had my 94 about 6 months now. Just replaced all hoses and thermostat (boiled to 180). All parts are OEM from Wits End. My temp gauge is normally just under the 3 o clock position and that’s where it’s is currently. I’ve let it run for 25+ minutes and the lower hose is still cool to the touch and I haven’t seen a large drop in the fluid level. Shouldn’t the lower hose get hot like the upper?
Thanks in advance.
 
IF the T-stat has opened...then yes, the hoses (all of them) will be quite warm to the touch.

A better test would be to actually drive the vehicle (put a load on it)...then come back and feel the hoses. It's possible at 'idle' the engine simply isn't getting hot enough to cause the T-Stat to open.

Also, possible it is faulty.
 
Sounds like something might be off.... I agree with @flintknapper that at idle the engine wont warm up very quickly but after 25+ minutes I'd think it would warm up enough to open the thermostat.

Take it for a lap around the neighborhood and check again.
 
Sounds like something might be off.... I agree with @flintknapper that at idle the engine wont warm up very quickly but after 25+ minutes I'd think it would warm up enough to open the thermostat.

Take it for a lap around the neighborhood and check again.

The T-Stat on my 100 series will eventually open (some) at idle...especially on a hot summer day, but my 80 series (190°F) will sit at 186-188°F for a very long time. When doing any work on my 80 series that involves adding coolant and burping the system...I always have to set my hand throttle to elevate engine rpm (get it warm) or take it for a drive to get the T-Stat open far enough to really flow the coolant.

I'm sure everyone's cooling system is a bit different in terms of health and the temperature at the time. And I wouldn't expect the thermostatic wax element of the T-Stat to be more accurate than 2-3 degrees either way of the stated opening temp.
 
Sitting, parked, as long as it's not excessively hot condition, the cooling load will be low. The 1FZ is a bottom thermostat, bypass system. So with low load, most of the coolant will go through the bypass, little will be drawn from the radiator, just enough, as needed to keep the motor cool. So the slight radiator flow will make the upper hose hot, the fan/radiator will cool, so the lower hose will be cool.

If for whatever reason, you want to add load, could open the doors and set the A/C to max, or just take it for a drive?
 
Thanks for the replies! I’ll give it a run around the block when I get home and let you guys know.
 
Ran it around for about 45 minutes on the streets and highway. Temp stayed constant and ran great. Thanks for the inputs!
 
Ran it around for about 45 minutes on the streets and highway. Temp stayed constant and ran great. Thanks for the inputs!

Best to check/top the coolant level when it cools after each drive, for a few cycles, until it stabilizes. Also running the heat until the vent output gets hot, will flush any air from the heater circuit.
 
Back
Top Bottom