Tcase gear install help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 28, 2010
Threads
136
Messages
813
Location
FOG TOWN->SF<-
I’m in the process of doing a set of Transfercase gears. I’ve done a set before that didn’t have this issue but when I cracked the outter case off (1st case) a set of washers fell out. It goes in front of the upper bearing race pictured.

How do I reinstall without them falling out? I’m not planning on taking out the whole tcase out and leaving the half attached to the tranny. I was thinking of a little rtv but don’t know if it might affect clearance between the case and the race. If anyone has any mcgyver ways to leave it in place when I bolt it all back together please advise.
352D33E1-47DC-4E42-9FC8-579FA71852E4.webp
 
Clean everything to within an inch of its life with brake cleaner. I mean REALLY CLEAN. Dab some heavy grease like Lucas #2 on the parts and press them together. The grease will hold them in place and just dissolve with use. Don’t use RTV
 
^^^This
 
Back
Top Bottom