Tap High Beam Trigger Behind Dash

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

haulin auss

@_haulin_auss
SILVER Star
Joined
Mar 29, 2016
Threads
8
Messages
317
Location
Raleigh, NC
Hey all - I'm pretty shocked I haven't been able to find this searching, so please point me in the right direction if I've missed something.

I'm wiring up my new LP6's using a OEM seat heater switch for their high/low function. I'd like this to be triggered off of the high beams, which I know are negative-side switched.

Other than running a wire back in from the engine bay, is there a wire under the dash that's easy enough to tap into, either on the positive or negative side?

Full disclaimer, I haven't gotten in there with the multimeter yet because I honestly thought I'd find a million threads about this.

Thanks!
 
So, you mean only on with the high beams, correct? According to the schematic the high beam signal from the combo switch is a RED with YELLOW stripe. I've tried to attach the electrical manual. Page 70 is the headlight circuit. Looks to me like you should be able to find something to tap.
 

Attachments

So, you mean only on with the high beams, correct? According to the schematic the high beam signal from the combo switch is a RED with YELLOW stripe. I've tried to attach the electrical manual. Page 70 is the headlight circuit. Looks to me like you should be able to find something to tap.

Awesome, thank you! I’ll take a closer look this evening to see if I can find it and test it.
 
Back
Top Bottom