tail light problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2006
Threads
3
Messages
8
Location
mckinney
Just got my fj40 back on the road and will begin with an admission of electrical ignorance, or maybe just total ignorance. Anyway, my turn signals are not flashing and when my brake lights are on they illuminate the clear and amber lens on one side and the red on the other . Any ideas about how to check? Also, an exhaust manifold seems to be making a bunch of noise. whats the best way to remedy this. If I need a new or used manifold, where would I go to find one in the
dallas/ft. worth area. Appreciate the help in advance
 
di76fj said:
Just got my fj40 back on the road and will begin with an admission of electrical ignorance, or maybe just total ignorance. Anyway, my turn signals are not flashing and when my brake lights are on they illuminate the clear and amber lens on one side and the red on the other . Any ideas about how to check? Also, an exhaust manifold seems to be making a bunch of noise. whats the best way to remedy this. If I need a new or used manifold, where would I go to find one in the
dallas/ft. worth area. Appreciate the help in advance

On the electrical, sounds like a short that I just had. You need to isolate it down to a individual light. Mine ended up being my front drivers side turn signal. I unplug each turn signal one at a time and found the problem pretty fast after a day of looking for grounds.

Does your gauge cluster light up dimly with the ignition in the on position and the light switch off?
 
The turn signal / brake light problem is probably due to a bad ground on one or more of the light housings. When you have lights coming on at the wrong time it is usually due to a "floating ground". Use a temporary jumper wire to a known good ground to confirm that this is the problem. You may want to run a separate ground wire permanently as a fix.

Find out where the exhaust leak is first. If it is the gasket, get a new one and check the mounting surface to make sure it is flat.
 
Kealy,

I agree with PinHead on the ground. The rear turn signal/tail/stop lights all ground through the housing to the frame cross member. Clean the points where the mounting screws attach to the frame of all paint/crud/dirt and use star washers uner the heads of the screws and between the housing and the frame. Some dielectric grease doesn't hurt anything either.

Get youeself a short length of heater hose, a couple of feet long, and use that as a stethoscope to find your exhaust leak...one end to your ear, and move the other end along the manifold-head contact on top and underneath the manifold, where the exhaust pipe attaches to the manifold, in between the tubes of the manifold, etc. You'll know by the sound when you've found the leak. If it is the gasket, check the manifold for flatness against a pane of glass or a straight-edge. If it isn't flat within a few thousandths, take it to a machine shop and have it milled flat. Put things back together using two gaskets, Toyota OEM or Fel-Pro, stay away from Kevlar and other aftermarktes so I hear.

Be careful not to get your shirtsleeve or hair in the fan when you're checking for the leak!
Good luck,
Pete
 
Back
Top Bottom