It is that time when 280,000km plus worth of mostly off road driving compounded to suspension bushing replacement for my Nov. 1990 Australian Spec GXL manual tansmission. The steering has been erratic despite birf, tie rod etc rebuild/replacements.
I suspect the transfer case and engine mountings are shot too. During gear changes, there is percievable 'movement' felt. Shut down of the engine always ends with a 'cluck' and front end shake/shudder.
Planning on replacing all Panhard Rod and Radius Arm bushings front and rear. Then the mountings when funds filter through.
Has anyone attempted the job themselves ? How hard is the job and what tools required ?
Has anyone have any experience with the SuperPro P/U bushing kits from Australia ?
with thanks
Wallace
I suspect the transfer case and engine mountings are shot too. During gear changes, there is percievable 'movement' felt. Shut down of the engine always ends with a 'cluck' and front end shake/shudder.
Planning on replacing all Panhard Rod and Radius Arm bushings front and rear. Then the mountings when funds filter through.
Has anyone attempted the job themselves ? How hard is the job and what tools required ?
Has anyone have any experience with the SuperPro P/U bushing kits from Australia ?
with thanks
Wallace