Strangeness -

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

check your main ground

tucker74 said:
So the choke cable housing on my '9/72 FJ55 is getting hot for some reason - couldn't find any bare wires touching it ... or anything else hot for that matter. Any ideas (someone mentioned the idle solenoid)?

Tucker

could be bad and its grounding thru the choke cable.
i've seen nissans burn thru accel cables because of that ;)
 
The bad ground could be the issue. I had an f-150 that had a bad ground to frame and it would smoke any wire that was connected to the engine block. It essentially created a live (read hot) frame without a ground so the wires would act like a filament. Very odd. 10.00 ground wire (read cable) from starter to frame cured it instantly.

Another consequence of this scenario would be that the starter would not shut down when the ignition was turned off. I would have to take off the Pos bat cable to kill the starter.

The ground cable was the LAST I replaced thinking it just could not be that simple i.e. replaced solenoid, positive cable etc..

Try that
 
Should be a large grounding cable/mesh from the starter bolt on the engine block going to the frame near the battery tray. If it is there, I'd clean up the contacts. If not, it should be.
 
What everyone is saying is you have a bad main battery to engine/frame ground. You need to make sure you have a battery to engine(your negative, black battery cable), then an engine to frame ground of LARGE ga wire. Corrosion will cause the resistance of the cables to go up over time. I know on my 1971 that the engine to battery ground was corroded badly causing a very high resistance in the cable. This resulted in a slow draggy starter. I replaced it, the + battery cable for good measure and the engine to frame ground and the problem was gone. If your ground is bad then starter current is trying to flow to ground through whatever is handy, in your case the choke cable... Replace your main grounds. Make sure to clean the frame/engine to bare metal where the cables bolt and you may even want to use a tap tp clean out the holes. After connecting everything back up spray them with a shot of black paint to help protect them. You'll be good for another 20 years :-)
 
tucker74 said:
I just replaced the battery cables - positive to starter (w/ fusable link) and negative to frame (ground and tapped). I didn't do anything from the starter/block to the frame - is this what I'm missing?

BTW - starter was turning slow ...

Tucker
Yes.
 
Back
Top Bottom