Steering/wandering issue...need help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Lots of info about the steering box in this thread. I would tighten front bearings and big nut to spec and go from there.
Gear box discuss. Tons of info but you have to search deep into the library for specifics. Its all on here somewhere.

May I ask - how much did the rebuild cost? I just took delivery of my 96 LX450 and its got a ton of play in the wheel which absolutely drives me nuts about it, especially after my daily driver has no play whatsoever. thanks.

And Next on the List: Rebuild PS Gear Box/New Sector Shaft/Pitman Arm
Front wheel bearing torque, it helped steering feel the most for my truck. Not to tight...not to looooose!
Front Wheel Bearing Play 1996 - Question
 
Front wheel bearing torque spec is 43 ft/lb. It's easy to check/adjust and should not be done 'by feel'.
 
I tend to agree with SRS. My own GCC spec model 80 has the same behavior after all bushings replaced and bearings checked. About 350k km on the clock. I had the guys adjust the nut on the existing steering box and it helped a bit, but it was still -just- enough to be annoying.

The neighboring Emirate, Sharjah, has a bunch of land cruiser dismantlers. Mostly AUS trucks, so RHD steering boxes are plentiful and cheap.
full

They only wanted 150 AED for this one--about 40 USD.

The LHD version, which was sold here when new, are much less common and a lot more expensive, and you don't have much to choose from. I ended up buying the dirty one in the back because it had a smidge less play. Very little play, actually.
full

I paid 800 AED for it, which is about 220 USD. I'm having it cleaned up and installed and am crossing my fingers that this is the issue. These things are darned heavy. Felt like it weighed at least 60 pounds. I will post again after the install.
 
Last edited:
....I paid 800 AED for it, which is about 220 USD. I'm having it cleaned up and installed and am crossing my fingers that this is the issue. These things are darned heavy. Felt like it weighed at least 60 pounds. I will post again after the install.

Looking forward to the update.
 
Lots of info about the steering box in this thread. I would tighten front bearings and big nut to spec and go from there.
Gear box discuss. Tons of info but you have to search deep into the library for specifics. Its all on here somewhere.

@HARDGEAR - thanks for the thread pointers - quite helpful!
 
A steering box for an 80 weighs about 15 kg without a pitman arm fitted. Given that it's the *only* part interfacing between steering wheel input from the driver and directional control of up to 3 tonnes of vehicle, you want it to be a tough nut!

Given that I've now discovered at least three revisions for the 80/105 series RHD steering box (44110-60200 in early 80's, then from 7/92 up 44110-60201 [also used in 105 series at least up to 2002], then theres another one with 44110-60202 part number), I guess the design has been updated and made more rugged over time.

The pitman arms change too - for RHD there's 45411-60200 for early 80's, then later it went to 45411-60201 (about the time the steering box was updated). For the most recent steering box revision (44110-60202) I keep seeing references to a pitman arm with p/n 45411-60350.

All the part-numbers of the steering boxes and pitman arms *seem* to be substitutable when plugged into Toyodiy but not 100 pct sure on that.
 
Back
Top Bottom