I almost swallered my spoon eating my cereal !!! I’d like some of that action too...!
Sometimes I surprise myself-NOS 45 taillight gasket
- Thread starter 65swb45
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I almost swallered my spoon eating my cereal !!! I’d like some of that action too...! I’d take at least 2 sets if I am not sucking hind tit already...!
I am unaware of what a “terminal motor cover” is at this time, but I don’t doubt I might NEED some !
Is this where the wiring attaches to the wiper motors ? I don’t know if my ‘67 45 ever had those on it since I owned it. I will check out SOR and see what everyone is talking about.
Is this where the wiring attaches to the wiper motors ? I don’t know if my ‘67 45 ever had those on it since I owned it. I will check out SOR and see what everyone is talking about.
I would like a pair if you have any left...how much are you asking ? When are they going to be available ?
These haven't been made yet, hopefully one day they will be reproduced.
So the pictures Andy sent above are original terminal covers ...I see.
What about the tail light lenses?
Probably not enough to go around and feed all of us “guppies!”
Probably not enough to go around and feed all of us “guppies!”
Both 2 bulb and 3 bulb lenses are available. Cruiser Outfitters has them. Other Cruiser parts suppliers might have them also.
Last edited:
Pardion helped supply me with a couple of old Red/clear Stout lenses. Thanks for your help on the gaskets at Cruiser Outfitters... My brother in law put John’s lenses on, but I never knew where to get new gaskets. I thought someone else told me that, but when I went to the site I couldn’t find the 2 build gaskets.
Cruiser Outfitters just has the lenses, gaskets (for 2 bulb tail lights) don't exist yet. Hopefully these will be reproduced one day also.
i will be in for a couple of taillight gasket sets when available, thanks
Last edited:
I would like 3 Pair of these Taillight Gaskets, when made, please.
Any progress here?
- Thread starter
- #56
That’s a good question. I’ve thought about it a few times in the last three months, but I’m never near my computer when I think of it. And by the time I am....
I haven't forgotten about this project. The mould is finished. Will need another couple of months to go through production.