Sliders - Rub Rail

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 7, 2015
Threads
27
Messages
1,228
Location
Eastern Washington
For those that have sliders how far does the tube "rub rail" portion stick out? I see some that are straight and some with a little bulge near the rear door. Trying to get an idea of how far they stick out say relative to the sheet metal or maybe the tires. Are most even with the edge of the tire or do they stick out further? Think you'd want them at least out past the widest point of the door skin to reduce damage but how far is too far? I am to that portion of my slider build and looking for suggestions and/or measurements. Thanks!
 
My WKOR 10 degree sliders stick out far enough for a comfortable step.
jQQuR61.jpg


You can see below that the square tube runs parallel with the door sill/rocker panel.
VldbqGI.jpg
 
I made those on my mill; they're 1/2" angel iron. The teeth are made with a 3/8" end mill, .125" deep from the point on .400" centers.
They work fantastic. Been on there since Thanksgiving 2019. Zero slippage issues they are just like dirt bike pegs.
 
The closest thing I could find were weldable ladder steps, but even those I wasn't impressed.
I was originally thinking about wraping the top in expanded metal, but it looked horrible, very Mad Max, but not a cool Mad Max.
 
Back
Top Bottom