Should i just do a conversion?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 27, 2018
Threads
2
Messages
4
Location
Missouri
So I got into the front and rear axles today and brakes all will need some work.

Rest of the axle components are decent and will just repack hubs and the knuckles I think.

I already need a new master cylinder.

Questions:

1. Should I just do a disc brake conversion? I'm not worried about the performance of drums- it's not a wheeler. It's for taking a few dirt roads and driving to the lake nearby

2. Can I just pull everything off back to the knuckle and clean/ repack? Or should I really get all the way to pulling the knuckle out?
 
I shouldve added I dont particularly want to source a donor axle- I just dont have time. I'd be looking for a kit online
 
I would avoid an online 'kit'. Read the FAQs and do some searching. The kits are a compromise at best.

Given your usage, just do a good rebuild on your drum brakes and run it. If you have an old single circuit master cylinder, I would seriously look at upgrading to a dual circuit master, at the very least.
 
Back
Top Bottom