Shackle Reversal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 5, 2003
Threads
250
Messages
5,475
Location
Iowa Park. TX
Can I do the shackle mounts under the frame instead of through the frame? I sa Texican's and they are through the frame and look like they work damn good. My exhaust is in the way and I don't want to have to reroute it.
 
when I did my reversal I wasn't able to put the shackle through the frame because of the header was in the way. Now that I've done the SBC swap I'm planing on putting it through the frame. Should lower it a bit and shorten my rear shackles. If you are not able to put it through the frame it will work fine. I've been running it that way for a couple years without a problem.
 
Not sprung over but have some monster shackles that act like rock finders. I was thinking about using the stock mounts, just cutting the rivets and switching them around and rewelding. Or I could buy some new ones.
 
DavidW said:
I was thinking about using the stock mounts, just cutting the rivets and switching them around and rewelding. Or I could buy some new ones.

You can buy spring hangers but the factory one work great and they are free.
 
Last edited:
I would vote to go through the frame .the spring angle is already compromised with a through frame mount shackle reversal as the front is pushed up higher than normal.by putting the shackle in the frame you help to level the spring pack to its optimum ride position which is generally close to level front to back .
 
Here are a couple of pics of my shackle reversal with the shackle under the frame. I know the caster is off a bit but rotating the perches is not to tough. It did raise the rig a bit (I am using the long ***P Wrangler shackles in the back to level it out). I figure the only real reason to go through the frame is to keep height as low as possible.
 
Last edited:
I run 35's with a 2" body lift so I will need the longer shackles. I guess that I can use the degree shims that I got to use with the shackles in the front. They are 6* and might be a little too much.
 
I am running 2.5" lift springs & 35's. I think with this shackle set up it is probably a total of about 4" over stock. It rides nice (relative to a Cruiser ride of course). I think the shims would work- your 6 degree may be perfect. Good Look. Let us know how it turns out!
 
i would like to see close up of texican's reversal.
 
Back
Top Bottom