selectable aussie locker??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 27, 2003
Threads
490
Messages
9,929
Location
North Cadillac
i went out to test the rear aussie this evening and something strange happened.

First, as soon as i got to a good ditch to cross i shifted into low range and the ABS/ center diff light did not come on. I thought, what the heck, it will come on as i move a few feet. Well, as i started to cross up i started to feel the wheels spin and i look back at the rear DS tire, and it's not spinning! I thought WTF? So i pushed in the center diff lock button, lights came on and the center diff locked and i climbed right out of the ditch! I drove a few more feet, pushed the center diff lock button and the light went off (still in L range).

Puzzled i pulled out of the trail and onto the street. put the rig in High range. Drove in a tight circle in a culdesac and you could hear the rear aussie clicking like it's supposed to. I then pushed the center diff button, lights came on, started driving in a tight circle and you could feel/hear the rear binding as the locker was in full effect.

Also, i have not done the Pin 7 mod.

So, it seems like now my center diff lock is effected by the button only? It also almost makes the aussie selectable which is really pretty cool. :bounce::steer:
 
No commenta?? is this the pin 9 mod :D

It was odd driving in fj40z just hours before on the same ground it did not seem to act differently b/w high range and low. That is it unlocked and ratched in low range.
 
did you hold one wheel and spin the other other as directed in the instructions? then repeat it in the other direction, then with the other wheel. This will tell you if the locker is working as it should. you will notice a difference when turning with the center diff locked. there will be more resistance and tire scrub esp on the road, but the aussie should not react any different weather in high or low range.
 
do you have a VC?

is it even remotely possible, that you, center diff UNlocked, were spinning an out of sight tire?

You can forget about the "selectable" part. I have a feeling, either you don't have a Vc, or it hadn't "humped" yet, to hit the other shaft to give the diff torque.


Oh, and another thing. B/c you have a locker in whichever axle, it now has to overcome even more to spin. So therefore, it is the wheel w/ the most traction, focusing the "spin out" to the other axle.
 
Last edited:
I would suspect that your center diff was still open, and one of your front tires was spinning--therefore, very little torque to your rear axle.

That's right. Automatic lockers stay locked based on torque - if you are in AWD with a front spinning there is nothing to keep the Aussie locked.

CDL on and torque is properly applied and the locker works. You just found out why auto lockers and AWD with an auto tranny are a nice combo onroad.
 
Okay, sorry for the (sort of) hijack. So this is not like the ARB air locker? This automatically does it? If so, how much, and can you put it in a semi-floater? I'm interested in this. Any/ all explanations would be appreciated. I haven't really started looking into too many mods yet. Still just doing PM, and the work/school thing. : ). Thanks.
 
see what you did Concrete?








Okay, sorry for the (sort of) hijack. So this is not like the ARB air locker? This automatically does it? If so, how much, and can you put it in a semi-floater? I'm interested in this. Any/ all explanations would be appreciated. I haven't really started looking into too many mods yet. Still just doing PM, and the work/school thing. : ). Thanks.




No, nothing to do with it. Concrete just thought he stumbled onto something and jumped the gun with his choice for a title.
 
actually the title was purposely created to get some attention and up the # of viewers initially......... but good guess:rolleyes:

and yes pookie, this is different than the selectable ARB lockers. It is an automatic full time locker that you can have to your door for under 300 bux and can put in a semifloat in an afternoon.

For the best explanation and education check out the diffs for dummies section in the FAQ; it will explain differentials and lockers very well.
 
yes, the name was selected purposely so i could get a lot of looks; kinda' like asking what tire size or lift size.

anywho, i was under a different impression on how this "auto locker" would function. I figured it was locked full time. However, that is not exactly the case. On the road you can't even tell it's back there. Only if you roll the window down, turn the stereo off and stick your head out the window during full turn you can hear a click,click,click,click. With the center diff locked doing the same thing, it is totally locked.

I had ASSumed that the rear was locked, period. It would not be influenced by the t-case. So, no tire spinning regardless of being in low, high, t-case locked or not. I guess i was wrong.

It is a pleasant surprise.


Pookie, it's not selectable in the same sense that an ARB is. However, i think it's probably the next best thing.
 
Last edited:
actually the title was purposely created to get some attention and up the # of viewers initially......... but good guess:rolleyes:

yes, the name was selected purposely so i could get a lot of looks; kinda' like asking what tire size or lift size.



:lol::lol::lol::lol::lol:


If that's the case, then I'm gonna start my next post off with, "Free beer and hot chicks!!"


Sorry, I know that's not tech. I'll let y'all go back to the morgue setting....sorry.
 
anywho, i was under a different impression on how this "auto locker" would function. I figured it was locked full time. However, that is not exactly the case. On the road you can't even tell it's back there. Only if you roll the window down, turn the stereo off and stick your head out the window during full turn you can hear a click,click,click,click. With the center diff locked doing the same thing, it is totally locked.

I had ASSumed that the rear was locked, period. It would not be influenced by the t-case. So, no tire spinning regardless of being in low, high, t-case locked or not. I guess i was wrong.


The only rule with the Aussie Locker is that if you've got (enough) torque going to the rear axle--the Aussie WILL be locked. By its nature, the more torque you send to it, the "more locked" it is.

So don't make the mistake of thinking that an open center diff means that your Aussie Locker will not lock-up. In fact, I would bet that in the above scenario it WAS locked, but with the center diff open and a front wheel spinning, you weren't getting enough torque to the rear axle to move the truck--regardless of the rear axle being locked.
With the center diff open, it only takes one slipping wheel to rob all your power (viscous coupler not withstanding). The Aussie Locker doesn't change this.

The Aussie will lock up with the center diff open. In fact, I have found it advantageous to run in low-range, with the center un-locked (courtesy of a CDL switch and pin-7 mod) when negotiating mild, grippy terrain (slickrock) with a heavy load. Running in low helps with the heavy load, the open center diff makes tight turns much more pleasant, and the Aussie DOES add traction under some circumstances.
 
do you guys think that this is an indication that my viscous coupler is not up to par?

Yes, i had a front wheel spinning with the CDL not locked when i looked back and had a rear tire not spinning. Locked the CDL and the rear immediately locked up.

Also, thank you Hayes for the great write-up!! I followed that guide along with the instructions for an easy install. Had your write-up not been in place i may have never even purchased the aussie.
 
do you guys think that this is an indication that my viscous coupler is not up to par?

Yes, i had a front wheel spinning with the CDL not locked when i looked back and had a rear tire not spinning. Locked the CDL and the rear immediately locked up.

Also, thank you Hayes for the great write-up!! I followed that guide along with the instructions for an easy install. Had your write-up not been in place i may have never even purchased the aussie.

I doubt there is anything wrong with your VSC. VSC's are not lockers they don't send 100% of power. Meaning if one side of VSC is in the air other side does not move because any percentage of the force that = to 0 is still 0.
 
do you guys think that this is an indication that my viscous coupler is not up to par?

Yes, i had a front wheel spinning with the CDL not locked when i looked back and had a rear tire not spinning. Locked the CDL and the rear immediately locked up.

Also, thank you Hayes for the great write-up!! I followed that guide along with the instructions for an easy install. Had your write-up not been in place i may have never even purchased the aussie.

No. You just experienced the difference between the reality of torque transfer systems and the marketing of torque transfer systems. If there is zero traction on one wheel in an AWD system almost all the power will go to that wheel.

Another way of saying this is AWD is 1WD in severe offroad conditions. As Hayes said, you may have been locked, but it didn't matter. Your VC should be considered useful only in low traction road conditions (snow).

Your locker is designed to allow differentiation of wheel speed onroad - otherwise you would scrub your tires around every turn (a spool). In low range they generally stay locked and behave like a spool, but again, that doesn't matter in an AWD system where a wheel on the opposite axle has no traction.

What was "selectable" in your experience was CDL - it was the center locked/unlocked, not the locker.
 
However, that is not exactly the case. On the road you can't even tell it's back there. Only if you roll the window down, turn the stereo off and stick your head out the window during full turn you can hear a click,click,click,click.
It is a pleasant surprise.
Is the aussie really that much quieter and smoother? if you had installed the lockrite instead, you could also make loud popping and clanking noises. i like peoples reactions to low speed parking lot maneuvers featuring clicking, popping, banging noises accompanied by jerking and tire chirping. Being a light weight mini truck with a manual tranny probably doesn't help. My experience with auto locker road manners definitely influenced my decision to find a factory (selectable) locked 80.
 
Is the aussie really that much quieter and smoother? if you had installed the lockrite instead, you could also make loud popping and clanking noises. i like peoples reactions to low speed parking lot maneuvers featuring clicking, popping, banging noises accompanied by jerking and tire chirping. Being a light weight mini truck with a manual tranny probably doesn't help. My experience with auto locker road manners definitely influenced my decision to find a factory (selectable) locked 80.

AWD and an auto transmission means that auto-lockers are typically just about transparent unless you have sudden coast to throttle or vice versa during times of wheel speed differentiation (turning).

In other words, if you are coasting or at very low throttle in a parking lot, you'll hear it clicking at it allows a lot of differentiation at low speeds, but that's it. On the highway or backroads at speed, you wont even know it is there. If you drop the hammer into a turn in the city, it will probably make itself known.

This isn't a feature so much of the Aussie as the rig in which it is installed (AWD/auto). Any of these auto lockers are what I would consider to be a nightmare in a manual transmission application, because the act of shifting itself will cause engagement/disengagement, something that does not occur with the auto.
 
Back
Top Bottom