Scab Plate Help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 4, 2006
Threads
27
Messages
698
Location
Western Wa.
I'm installing a scab plate from BTB products on my cruiser and am having some issues with the length of the plates, they stick out further than the frame rails. Has anyone else had this problem or is it possible that the previous owner for some reason cut the frame shorter (he did hack up a lot of the truck). Any feedback would be nice. Thanks
 
Last edited:
My kit also has about a 1/2 inch overhang. No biggy. It boxes the whole frame end so I am going to drill it and tap it for bumper brackets (when I get that far) and go with the extra 1/2" of length.
 
Thanks guys, I think i'll extend out the frame a couple inches so the steering box has a little more room.
 
i was thinking of hacking into the front part of my frame a little bit to get better aproach angle, is there any reason not to do this? will there still be room for a winch? (dont have my cruiser available to look)
 
Issues

Does anyone know if there will be a problem if I cut through the shackle mount to make room for the bolt on the PS box?
 
Last edited:
Oops deleted all my attachments
Picture 015.webp
Picture 016.webp
 
Back
Top Bottom