Same size but different brand?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
101
Messages
513
Location
Alpharetta GA
Has anyone had problems with running the same size tires but different brands? Currently I am still stock with this set up and tread wear is about the same, can this still cause problems with my t-case? Thanks guys. I think I will finally change my rear u-joints today because it is absolutely dead at work. I'll let yall know how it comes out.
 
You may or may not run into trouble. Tires in the same size from different manufactureers may vary quite a bit in overall diameter... sometimes up to an inch. That said... ss long as your tires have roughly the same rolling radius, it shouldn't make any difference mechanically if all 4 are different brands. The easiest thing to do is to park on a flat garage floor and measure from the ground to the center of your hub on all 4 wheels to get the rolling radius of the tires. If all are within ~1% you are golden.

~Chris
 
Thanks Chris, I will try measuring tonight, I have some take off 265/75/16's that are only 1/4% worn off a new H3 that I might throw on for the time being. They almost look a little smaller than stock though. Not sure what a 275/70/16 measures out to be.
 
Yes I would change all 4, but I think I might wait because they look a little smaller. I am chasing a noise/vibration at hwy speeds in which I am going to address on another thread.
 
As long as all the tires on the vehicle have the same circumference (or very close), you should have no center diff issues, no matter whether they are the original size or other.
 
On average the 265/75 tire will be 1/2" taller than the stock tire.
 
Back
Top Bottom