rough idle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 13, 2006
Threads
21
Messages
58
My 92 has a very choppy idle, but holds at 700 rpm. Also has lost power at all rpm. It feels like it is running on 5 cylinders. This is what I have one so far; new plugs and wires, cap and rotor and changed the coil, but it still has the same problem. I also checked for vaccum and air leaks by spraying carb cleaner all over the base of the manifold and plenum. There are no fuel leaks and no smell out of the exhaust. My gut tells me it could be the injectors probably not firing right. Any ideas anyone.
 
My 92 has a very choppy idle, but holds at 700 rpm. Also has lost power at all rpm. It feels like it is running on 5 cylinders. This is what I have one so far; new plugs and wires, cap and rotor and changed the coil, but it still has the same problem. I also checked for vaccum and air leaks by spraying carb cleaner all over the base of the manifold and plenum. There are no fuel leaks and no smell out of the exhaust. My gut tells me it could be the injectors probably not firing right. Any ideas anyone.

I had very similar symptoms (1fzfe not 3fe) and it ended up being the #6 injector. For me "very choppy" was definetely not an overstatement. It was enough to significantly shake the exhuast and engine. There was no mistaking that something was wrong. It would run "ok" at highway speeds but felt like it was significantly short on power.

In addition to what you've already done you might also replace the fuel filter and run the 02 sensor checks listed in the FSM.
 
The good thing is that I checked compression, and all cylinders came in within 5psi 135-140, so atleast I know there is some life still left on the engine. What I was able to determine was that the num 2 injector is not working. I was able to check for resistence and the injector did not respond. Just to make sure I unplugged each spark plug wire on at a time to see any varience in the idle. Number 2 was the only one that did not change. Hopefully this solves the problem. By the way is this correct that resistence should be at 13-14ohms? ecause the injector did not register anyresistence.
 
Again from the FSM (hint hint)

2. INSPECT INJECTOR RESISTANCE
(a) Disconnect the injector connector.
(b) Using an ohmmeter, measure the resistance between the terminals.
Resistance: Approx. 13.8
If the resistance is not as specified, replace the injector.
(c) Reconnect the injector connector.
 
Back
Top Bottom