- Thread starter
- #21
Thanks Brian, for your awesome link above for helping me make the design. You can't quite see it on the pictures, but I made the height adjustable so I can make it lower when I am working on the top or bottom. You need it this height to spin it on end.
Overall, really happy with it, there is some slop such that the arms droop down a little, but I think I can shim it up in a couple spots and take care of it. If not, I can weld up new arms that allow for the angle. That may be easier.
Overall, really happy with it, there is some slop such that the arms droop down a little, but I think I can shim it up in a couple spots and take care of it. If not, I can weld up new arms that allow for the angle. That may be easier.