Retro Fitting Electric Seats

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 27, 2006
Threads
77
Messages
1,152
Location
The Land of Frank Rizzo
Has anyone replaced their non-electric seats with electric seats, I have manual seats in a 94LC and have a chance to install electric seats out of 96 LX450.

Will it work and what headaches can I look forward to?


Second question would deal with the stereo that's in the LX, will it fit into the 94 and will it work with the existing wiring?

Thanks,
 
In the land of junk yards, there seems to be a great deal of electric seats out there, and I agree that the manual seats are fine, especially if your the only one driving your cruiser.
Resurfacing your seats will cost you an arm and a leg, hell I could buy some nice Lexus grade tan leather seats for less and have 6 way power seat to boot. I just have to figure out whether or not they will be able to function in the 94.
 
Well since the seat controls and motor are all "on-board" the seat, all you need is a switched 12v dc source and a grounding point.

IIRC I could see a pigtail on the floor under my manual seat which leads me to believe the harness is already there, but if it isn't, it's a 1/2 :banana: job to run a hot lead from somewhere under the dash, under the centre console, and under the seat.
 
Well since the seat controls and motor are all "on-board" the seat, all you need is a switched 12v dc source and a grounding point.

Actually the seat sees constant 12v, otherwise how would you adjust them to get in and start the vehicle :doh:.

On another front, the electric seats will reduce your leg room.

The first thing I'd do is look under the front seats of your truck and see if the connector is there under the carpeting. If it is it's a plug and play install.
 
I can give you 1/2 the answer: the leather electric seats weigh a little over 60 lbs a piece.
 
Back
Top Bottom