Removing Oilpan

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 22, 2003
Threads
284
Messages
8,118
Location
Kansastitty
My engine is upside down on an engine stand. I've removed the 22 10mm bolts from the pan and I've driven a thin bladed putty knife almost all the way aroung the thing, under the gasket. I now have the thing picked up with the engine hoist and it is HANGING by the oilpan, engine stand and all.
What is the next step? Have I missed something???


HEP me!

Ed
 
Last edited:
They get on there hard. Use a propane torch to heat it up. Do not try and pry it off with anything between the pan and engine.
 
Romer said:
They get on there hard. Use a propane torch to heat it up. Do not try and pry it off with anything between the pan and engine.
We have at the shop a Wagner paint stripping heat gun, if you have one of these they work really well, without the danger of live flame......there is a chance of hydrocarbons in the pan igniting, and let me tell ya' this is scary and dangerous.....once years ago I was heating a stuck pan bolt on a Camaro,.BOOM!!!!
it blew the timing cover and both valve covers off all the bolts stayed, but sheared the sheet metal ......
My ears rang for hours.
Butch
 
Heat gun.....hmmmmm.....can do. I do have the head off, but all that weight hanging all night and not a budge. Maybe the oilpan is a good winch point?

Thanks,
Ed
 
When they're in the truck, a hydraulic jack between the pan and a frame member is the famed ticket, that is to say, side pressure, which briefly deforms the pan. Perhaps you can come up with something along those lines with it in the engine stand?
 
Texican said:
We have at the shop a Wagner paint stripping heat gun, if you have one of these they work really well, without the danger of live flame......there is a chance of hydrocarbons in the pan igniting, and let me tell ya' this is scary and dangerous.....once years ago I was heating a stuck pan bolt on a Camaro,.BOOM!!!!
it blew the timing cover and both valve covers off all the bolts stayed, but sheared the sheet metal ......
My ears rang for hours.
Butch


Damn, I never knew about that. Guess I was lucky. Nice thing to know Butch. Thanks
 
The heatgun did it. I just heated one side of it. Took about 6 minutes. I thought there would be all kinds of goo on the gasket, but it had nothing other than the one piece cork gasket.
Thanks for the tip Butch.


Ed
 
Texican said:
We have at the shop a Wagner paint stripping heat gun, if you have one of these they work really well, without the danger of live flame......there is a chance of hydrocarbons in the pan igniting, and let me tell ya' this is scary and dangerous.....once years ago I was heating a stuck pan bolt on a Camaro,.BOOM!!!!
it blew the timing cover and both valve covers off all the bolts stayed, but sheared the sheet metal ......
My ears rang for hours.
Butch


HAHAHAHA!
 
Degnol said:
The heatgun did it. I just heated one side of it. Took about 6 minutes. I thought there would be all kinds of goo on the gasket, but it had nothing other than the one piece cork gasket.
Thanks for the tip Butch.


Ed

:D :D :D :D :D :cheers:
 
Back
Top Bottom