Removing inner door panel from 93 LC

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 18, 2005
Threads
24
Messages
368
Location
Dallas
I've check out the FAQ's, didn't find anything in detail, also used the search function, now here I am.:eek:
My exterior door handle on my 93 LC is broken, it's the drivers door. Well I got to working on it yesterday and came to a stopping point where I didn't want to break anything.
I removed one screw from the inner door handle, another from the uppe arm rest. Pulled the window control switch out as well as the shell from door handle. Pulled back on the door panel and only got it removed to a point just below the arm rest. This is where I stopped.
Even had the flashlight up behind the door panel and couldn't see any screws holding it secure to the door frame!
Sorry for the noob question, I have gave up on it for now!

Thanks all
Aussie
 
There are two more near/under where your elbow would rest.

In mine I have to pop up the pad to access them
 
Look in FAQ under front door speaker rreplacememt. Also, look for Long Duck Dongs resent post on the same subject. He has pics with showing everything you need to do.

FSM shows the process also.
 
As dan mentioned there are two under the elbow rest (pops out), one under the top of arm handle where your hand would go to close the door from the inside look up from down low. You have to remove the platic piece behind the inner handle that opens the door. Remove the switch control panel completely and the light at the bottom needs to be popped out with a very small flat head screw driver and disconnected . Then there are the plastic snap in connectors around the full circumference of the door panel. Make sure to use a body panel tool if you have one or a long flat head screw driver and do them one at a time prying as close as you can to the connector itself. If you pry or pull from too far away you can break the mdf board itself or pull the plastic connector through it and loose the strength of that area on re-installation. Then when all is loose you need to angle the entire panel outward to get all the snap in fasteners completely out of their holes and slide the panel upward to release the top from the window channel. Its just that easy. :D
 
Ok here we go,

I read all you info and took it to the LC, within afew minutes I had the door panel off. Only tough spot was when that bugger of a key lock washer fell off and fell down below in the door panel, after afew :censor:ing naughty words I was able to retain the little washer.

Thanks all for the fabulous help!

Aussie

:cheers:
 
Last edited:
Back
Top Bottom